Monday 10 December 2018

Tinker Tinkeress in the Med

It was just over a year ago that I first used my Tinkeress in the Mediterranean little did I know at the time that I was going to be living in the same area a year later.


On the beach ready to go


I had only used the dinghy with an outboard to go around a bit in Fareham Creek. It was a sheltered area with strong tides and I did not go to far. I decided to go further out to sea as I am confident enough in the dinghy to do so.


Its a different world to the Solent


I took her about 4nm along the coast and it was a lot of fun and the views of the coast line were stunning. I did put a wet suit on as the sea is not as warm in the winter.



Strong winter sun



I tried a bit of fishing with a hand line but, did not catch anything not even sea weed. I would like to bring an anchor next time and try a bit of rod fishing. But, unfortunately all my anchors are still in the UK.


Amazing coast line


I found the little 2hp outboard was ok just a tad slow in the sea. I would like to try a larger outboard and according to the sales material she will take up to a 4hp outboard. I would also like to see how she performs with a British Seagull Outboard.



Calm seas



A short clip of me motoring around need to sort the date out on my gopro




Sunday 2 December 2018

Sevylor Tahiti Kayak

I brought a Sevylor Tahiti 2 + 1 kayak a couple of years ago. But, only used it a few times on the canal and once on Fareham Creek. It was ideal on the canal and easy to lift out to go past the locks. It was good on the Creek but, tides needed to be taken into account especially at springs.


Ready to be inflated 


I brought the Kayak down to Southern Spain on my boot rack on my Mazda Eunos so they are very easy to transport even in the smallest of cars. They are ideal Kayaks for taking on holidays or when storing a traditional kayak are not possible.


All ready to go



Yesterday the weather was really nice and rather than taking my other toy out I decided to take the Kayak out. It took me about five minutes to inflate and I was ready to go. The kayak performed very well and was a pleasure to paddle. I just need to sort the seat out a bit better for more comfort.


Going along the Coast


Heading out in calm seas


I did not go to far partly due to the seat and the paddle I had was not that good as I had lost one of the screws for it.


The beach I launched from

Wednesday 25 July 2018

Fareham - Newtown Creek - Fareham


It was a very calm day



It was another very hot day and I decided that I was going to spend the night on the hook in New Town Creek. New Town Creek is on the Isle of Wight and is a National Nature Reserve it is a very peaceful place to visit and one of my favourite places in the Solent. For anchoring it is well protected and has good holding I would highly recommend it to anyone.




On the hook

Wind was almost non existent F1/2 at times I decided to raise the main to catch what little wind I could. It was unusually quite for the Solent that was until I entered New Town Creek. It was like a water park people swimming, playing on water toys. The place was packed with Sailing boats small and large, ribs, motorboats jet skies I had never seen New Town Creek as full before.


Exploring the Creek

I decided to take the tender to explore a bit I could only land on the beach due low water. I decided to go for a swim as it was very hot. It was very refreshing to take a dip. Later on I deiced to to land and have a look round. It was like going back in time very peaceful and just the odd tourist.



A perfect place to park





I went back and had my dinner and a drink as the day turned to dusk the day sailors and ribs, power boats departed it was a different world. Just two other yachts on the hook. I watched the sunset and shortly after went to my bunk ready for an early start.


Such a peaceful evening 


Time for bed

The next day I arose shortly before sunrise. It was a struggle to raise the anchor and it was covered in mud. The day was calm and sadly I had to motor sail back.


A flat sea


Always something to see while entering Portsmouth

Friday 13 July 2018

Fareham - Folly In -Osbourne Bay - Fareham

The weather was very warm and the plan was to do some more work on Tallula but, the cabin was very warm and we decided to go for a sail instead.


 A reward for all the hard work


I noticed a big difference in how she performed and with full sails and the engine on tick over I easily exceeded the 5 knot speed limit in Portsmouth harbour. The difference from last time was profound. We decided to treat our self's after all the hard work to a glass of Prosecco. In years of sailing I have never touched a drop of alcohol while at sea but, on this occasion I decided  that a glass of Prosecco would be ok.


The Folly Inn moorings

The sail over was really nice not much wind force 3 at most but, with the clean hull and anti foul it was plenty. I was lucky to be able to get a walk ashore pontoon at the Folly Inn.

We had a lovely meal and a few drinks and yes they still dance on the tables.

The next day I decided to set of early to have breakfast on the hook I also decided to go for a swim the water was extremely cold and the moment I was fully in the sea I experienced cold water shock I could hardly move. I was pleased that I had a line to hold onto. I think I will put on a wet suit next time.


An early start

On the way back their was little to no wind so I motored back and the engine was running very well after the recent oil change.


Too cold for me


Heading back into Portsmouth

Monday 2 July 2018

The Heads

While Tallula was out of the water I decided that I was going to sort the heads out. A smelly dirty job that I was not looking forward to. I found that the heads would flush the waste out. But, the ball valve for the inlet was completely seized. Well the handle had corroded completely. Luckily they were closed and not open.



The valve was completely seized 


Old and new one




The plan was simple simply remove the old valve and fit a new one. Well that was what my intention was but, one thing lead to another and the small job just got bigger.

I unscrewed the jubilee clip and pulled, twisted, tugged but, the hose would not budge. I decided to cut it of with a Stanley knife but that did not go though it. I decided to go in with the heavy stuff the hack saw and it worked.

I then tried to remove the valve but, that too would not budge. I decided to spray some WD40 on it and had a coffee.


The new valve 

I drank my coffee and went back to it and got it of. I was really pleased with myself and decided that that despite the horrible smell I would also change the old hoses. The inlet one was not too bad but, the outlet one smelt bad and my hands had become covered in dark coloured grime. I did not really want to think to profoundly about what it may or may not be. So I decided to have a shower.


Goodbye smelly one

While I was removing the hoses the chipboard shelf broke upon further investigation the heads were on a piece of rotten chipboard.

I refitted the new valve using PDF tape and was pleaded with what I had done.

I took these home along with the toilet. I used the old one that the toilet was stood on and made a new one with plywood that I stained and covered in expoxy.


New toilet stand

My girlfriend agreed to hover the area after I had given it a good clean. She then painted the whole area for me with Dulex wet and dry. The smell was finally gone and it all looked nice and clean

I cut a new stand and shelf as the old ones had become rotten. I refitted the toilet with the new hoses. The one had a slight kink in it so I will need to shorten it slightly.


Not a nice look

I decided to apply some self adhesive tiles so the area could easily be cleaned and wiped down without having to worry about the paint work. The difference was amazing and it was well worth all the extra effort I now have heads that I am pleased with.


Much better with fresh paint


Finally 

Tuesday 19 June 2018

Time for a lift out

Last time I went out Tallula was struggling to reach hull speed let alone maintain it. In fact since I brought her she did seem a bit slow and I have no idea when she was last anti-fouled but, I suspect it was years ago.

The moment she was lifted out of the water it was clear that a scrub and anti-foul was overdue.




Out she comes 




As you can see she is really bad

The first thing I did was to give her a good jet wash to get of as much as I could. The yard turns the electric of after 17:00 due to noise complaints and it was already 16:00. After jet washing only one anode was still visable well what was left of it. I really did regret not bringing a change of cloths as I was covered in mud and barnicles. Next time I will bring spare cloths and wear protective eye wear as my eyes were hit several times from flying debris.


 I was shocked how bad she was below the waterline.




Getting the worst done before scraping



After the jet wash

It was nice to see that Tallula's hull was in good condition and the prop still sounded like a bell when I hit it with a key. I still had lots to do.





Monday 7 May 2018

Osbourne Bay

Saturday 5th May 2018

I was going to sail to Newtown Creek but, as I had to wait for high water in the afternoon and the warm weather I decided to sail to Osbourne Bay instead.

Osbourne Bay is close to Cowes on the Isle of Wight but, is a completely different world. I would highly recommend it to anyone who sails in the Solent.

The sail over was mostly motor sailing to my surprise their was not that many boats on the water I assume they had already arrived.




Such a peacefull sail over

On the sail over I only saw a few other yachts out which is very unsual for the Solent on As bank holiday weekend. I tried a bit of fishing but, the did not catch anything.




Apprough to Osbourne Bay


As I got closer I decided where I was going to drop the hook. I went to the spot and put the engine in neautral and put the anchor down and then reversed a bit. Took a bearing then another bearing I was happy the anchor was holding. So I opended a beer and watched the sunset.



Solent Sunset

I had not set an anchor alarm so checked though out the night to check despite getting up for the checks I slept very deeply and awoke a 05:00 in the morning to drink a coffee to the sun rise.


I really do like seeing the sun rise in the morning




Calm seas

I have a long list of things that I need to do but, fully intend to sail when I get the chance. 
 















































Monday 19 February 2018

RYA PWC Course

RYA Personal Watercraft Proficiency Course (Jet Ski)

I have always wanted to have a go on a jet ski despite seeing many idiots using them in an unsafe manor. So I decided to book myself onto the RYA PWC Course it is just a day course and at just £149 for the course very good value.

The following is from the RYA website:

Personal watercraft can be single seater machines or take two or three people. They are fast and exciting, but need to be handled with care.

Whether you just want to have a go on holiday or buy your own machine, our Personal Watercraft course will teach you how to get the best from it. Our course is designed for first time and experienced riders alike. Increasingly our certificate is required for launching in UK harbours, but is also needed if you use your PWC abroad.

All new PWs are sold with vouchers towards the cost of this course and, once passed, you are issued a certificate of proficiency.

Most courses take place over one day and can be taken on a centre's craft or your own.

The course started in the classroom with the usual stuff. What to wear on a jet ski and what safety equipment to take. It then touched briefly on rules of the road and bouys and charts. If you have done anything on the water before it will be very easy. The course was tault in a very relaxed manor.

I really did enjoy the course it was a good excuse just to have a play on a jet ski and I would recommend it to anyone who wants to have a go on one. 









Coral Moon

Coral Moon will be my fourth yacht. She is an Elizabethan 29 with a somewhat underpowered Yanmar 1GM10. When I went to pick her up ever...